Issue
The console reports information from multiple endpoints under a single endpoint.
Environment
This issue affects Windows endpoints.
Symptoms
- When viewing an endpoint's events, multiple endpoint names appear.
- When searching for an endpoint by name, it may not appear in the results. The endpoints table shows the endpoint most recently synced with the console.
Cause
When installing the Endpoint Agent, the agent generates a machine_id using the Windows Globally Unique Identifier (GUID). Once the endpoint registers with the console, the console assigns it a nebula_machine_id using the machine_id.
When endpoints share the same nebula_machine_id, they all report to the console as one endpoint. This happens when:
- Endpoints are cloned without running Sysprep.
- The Endpoint Agent is installed on a base image and registers with the console before generalization runs. To create a proper base image, see Prepare an image in Sysprep for endpoint agent.
To check an endpoint's machine_id and nebula_machine_id, run this command in Command Prompt on the endpoint:
"C:\Program Files\Malwarebytes Endpoint Agent\UserAgent\eacmd.exe" -getmachineidsResolution
To generate new IDs, the endpoint must run Endpoint Agent version 2.5.0.60 or later. To check the version, right-click the ThreatDown Endpoint Agent icon in the system tray > About, and find the Endpoint Service version. If the version is earlier than 2.5.0.60, update the agent first.
Complete the following steps on each affected endpoint:
- Open Command Prompt as an administrator.
- Run the following command to generate new IDs, replacing <password> with the Tamper Protection password from the endpoint's assigned policy:
"C:\Program Files\Malwarebytes Endpoint Agent\UserAgent\eacmd.exe" -GenerateNewMachineId -TamperProtectionPassword=<password>
- Wait 5 minutes for the command to finish. The command returns an error when it finishes. This is expected because it restarts the Endpoint Agent service.
- Run the following command to verify the IDs changed:
"C:\Program Files\Malwarebytes Endpoint Agent\UserAgent\eacmd.exe" -getmachineids
If the IDs don't change, contact ThreatDown Support.